Qt Based Klipper/Moonraker Control for RaspberryPi and other desktop systems, with a focus on touchscreen interaction.
It is best described as a software replacement for Klipper and Sonic pads that allows more freedom in selection of hardware and themes.
- Qt 6.8
- QuaZip https://github.com/stachenov/quazip/
- DAWidgets https://github.com/DigitalArtifex/DAWidgets
- QKlipper https://github.com/DigitalArtifex/QKlipper
- gstreamer
sudo apt-get install -y libgstreamer1.0-dev libgstreamer-plugins-base1.0-0 libgstreamer-plugins-base1.0-dev libgstreamer-plugins-bad1.0-0 libgstreamer-plugins-bad1.0-dev gstreamer1.0-plugins-ugly gstreamer1.0-tools gstreamer1.0-pipewire gstreamer1.0-qt6 gstreamer1.0-gl gstreamer1.0-gtk3 gstreamer1.0-libcamera gstreamer1.0-plugins-bad gstreamer1.0-plugins-base gstreamer1.0-plugins-good gstreamer1.0-libav gstreamer1.0-vaapi
Clone the QuaZip repo from https://github.com/stachenov/quazip/
git clone https://github.com/stachenov/quazip.git
cd quazip
To build QuaZip for Qt6, you will need to point it to the platform folder of your Qt6 installation. If you installed Qt6 through the Qt Maintenance Tool it will default to ~/Qt/ if run as a user or /opt/Qt/ if installed with sudo. The example assumes a root install.
cmake -B build -DCMAKE_PREFIX_PATH="/opt/Qt/6.8.0/gcc_64/lib/cmake/Qt6/" -DQUAZIP_QT_MAJOR_VERSION=6
cmake --build build --config Release
sudo cmake --install build
sudo cp /usr/local/lib/libquazip* /usr/lib
Follow the build/installation instructions located at https://github.com/DigitalArtifex/DAWidgets
This is a widgets library that can also be used in your version of QtCreator.
- Clone QKlipper
git clone https://github.com/DigitalArtifex/QKlipper.git
- Setup Build Directory
cd QKlipper/
mkdir -p build/release
cd build/release
- Run qt-cmake for the target version to configure the project
/opt/Qt/6.8.1/gcc_64/bin/qt-cmake -S ../../ -B ./
- Build
cmake --build ./
- Install
sudo cmake --install ./
- Clone Flo
git clone https://github.com/DigitalArtifex/Flo.git
- Setup Build Directory
cd Flo/
mkdir -p build/release
cd build/release
- Run qt-cmake for the target version to configure the project
/opt/Qt/6.8.1/gcc_64/bin/qt-cmake -S ../../ -B ./
- Build
cmake --build ./
It is important to note that FLO uses QtMultimedia to process webcam streams. While QtMultimedia defaults to FFMPEG, there are several known issues
that can occur while using this backend. If you have any issues (i.e. system lockups, scan lines etc) it may be necessary to specify the native backend
for your system. For example, on Linux the native backend is gstreamer and therefore would set the Media Backend option in System Settings to GStreamer